Vass H-Series Electrobar Busway Systems are manufactured in Standard lengths of 3.0 and any combination of special ready-to-erect lengths to satisfy customer’s specific requirements.
These sections together with our standard switchboard/transformer connection flanges, elbows (bends), tees, offsets and terminations form a modular series of building blocks that will adapt itself to any requirement.
However, we pride ourselves on our service, quality, capability and willingness to manufacture special sections, to achieve maximum design flexibility and to suit the most difficult installation requirements. Please click here to view some examples.
|Conductor Material||Service||CURRENT RANGE (AMP)||Earthing System||DEGREE OF PROTECTION|
|1 Ø 2W(DC2W)
3 Ø 3W
3 Ø 4W2N
We also have an extensive range of Take Off Boxes that are available. Apart from our standard range, some of which are listed below, we are able to manufacture any Take Off Boxes to suit any requirement.
Take Off Box Range
|Service||Single phase (240v) or DC to 440v
Three Phase (440v)
|Current||Take off Boxes up to 1600 amps(for currents greater than this please consult you Vass Electrobar representative).|
|Circuit Protection Device||HRC
Combination Fuse Switch
Fuse Switch Disconnect
Earth Leakage Circuit Breakers (Residual Current Device)
Note: Any protection device manufacturer/supplier can be specified.
|Accessories||Any accessory can be added to our Electrobar Take Off Boxes to suit specific customer requirements, including but not limited to the ability to connect to specific building automation and management systems.|
Vass is able to manufacture specific Take Of Box to suit your requirements.